Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

C2754 Engine Trouble Code

Meaning of C2754 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C2754 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for C2754 code is occuring now you should check C2754 repair processes.
Now don't ask yourself; What should you do with C2754 code ?
The solution is here :

C2754 Possible Solution:

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

C2754 Code Meaning :

C	2	7	5	4
OBD-II Diagnostic Chassis (C) Trouble Code For Engine	Fuel And Air Metering (Injector Circuit Malfunctions Only)	Fuel Rail Pressure Sensor Circuit Malfunction	Cylinder 1 Injector Circuit Low	Timing Reference High Resolution Signal A Too Many Pulses

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C2754 OBD-II Diagnostic Chassis (C) Trouble Code Description

C2754 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For C2754 Code

The reason of C2754 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

C2754 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

	Example: 0140